Mosaic tile square Mix SM 201

PRODUCT DESCRIPTION

The Mosaic tile square Mix SM 201 combines a mother-of-pearl colour description with a glittering mosaic surface. The supplied material field identifies natural stone, giving the product a different technical starting point from a glass mosaic with a similar pearly appearance. Its smaller square arrangement brings detail into the wall, allowing the finish and the repeated pattern to contribute together to the look of the installed surface.

A pearly-looking mix can be considered alongside several surrounding colours rather than treated as a single flat shade. Compare the complete mosaic with adjacent tiles, paint and fittings to decide which relationships you want to emphasise. The pattern can be used within a defined feature or repeated more widely, with the amount of area covered influencing how strongly the surface detail becomes part of the room.

MATERIAL & THIN SHEET FORMAT

The technical record lists a 30.5 × 30.5 cm sheet and a 2 mm thickness. That thin overall format is an important point to review where the mosaic will meet another surface. The dimensions refer to the complete sheet rather than each small piece, so consider both the physical panel and the finer square arrangement within it when comparing products or planning a decorative area.

The backing is mesh-glued, bringing the pieces together as a sheet. Check how panels will align and how the joints will continue across the full installation, including edges and openings. The natural-stone material entry should also guide the discussion about suitable installation products and care. Do not apply instructions for an unrelated glass or ceramic mosaic simply because the colour or surface appearance seems similar.

STATED WALL APPLICATIONS

The specification lists wall use and indoor scope, naming bathrooms, kitchens, living rooms and permanently wet areas. Use those product-specific applications as the basis for the project discussion rather than assuming that a decorative mosaic is suitable for every surface in those rooms. A floor, outdoor or swimming-pool application is not established by the supplied entries and should not be added from appearance alone.

For a wet location, confirm the exact fitting system and surface preparation with your installer. The product's visual character does not replace those practical checks. On a decorative interior wall, think about how the pearly-looking finish will sit beside simpler materials and how much of the fine square pattern will remain visible. The choice of location should bring the desired design effect together with confirmed technical suitability.

BUYING & INSTALLATION PLANNING

The catalogue currently offers per-sheet and square-metre buying options. Confirm which unit is selected before calculating the order and check the coverage information for this exact product. Measure the whole intended area, including separate sections, and note any corners or openings that may require cuts. Consider an additional allowance in relation to the actual arrangement rather than assuming the measured surface will equal the final purchase quantity.

Before purchasing the Mosaic tile square Mix SM 201, review the material entry and 2 mm thickness alongside the surrounding finishes. Agree appropriate installation materials, edge treatment and care requirements with the installer. The separate technical table retains the recorded information for reference, while the description sets out the product's particular combination of pearly colour, glittering appearance and fine square mosaic detail for an indoor wall scheme.

SPECIFICATIONS